To get an oven ready for a final inspection, take out the racks and trays to soak, coat the inside with a bicarb soda paste (or a commercial oven cleaner used exactly as the label says), leave it to work for several hours or overnight, then scrape, wipe and rinse. Finish with the door glass, seals, knobs and the outside, because inspectors open the door and look at all of it.
What the inspector is looking for
Consumer Affairs Victoria’s cleanliness guideline says cooking appliances, including the oven, stove and rangehood, should be free of oil, grease and food stains in a reasonably clean property. You are aiming for no baked-on deposits, no grease film on the glass and no crumbs in the drawer or the door. Discolouration that was there when you moved in, and that your condition report records, is not your problem to fix.
Before you start
- Check the oven type. Look at the manual or the model number online. Pyrolytic (self-cleaning) ovens and ovens with catalytic liners need different treatment, covered below.
- Turn the oven off and let it cool completely. Switch it off at the wall or isolating switch if you can reach it safely.
- Ventilate. Open a window and turn on the rangehood.
- Protect yourself. Wear rubber gloves, and eye protection if you use a commercial oven cleaner.
What you need
- Bicarb soda and water, or a commercial oven cleaner suited to your oven
- White vinegar in a spray bottle
- Dishwashing liquid
- A plastic scraper or old plastic card
- Non-scratch scourers, microfibre cloths and an old toothbrush
- Old towels or newspaper for the floor
Step by step: a standard oven
- Remove racks, trays and side rails. Most side rails lift or unscrew out. Set them aside to soak (see the next section).
- Scrape out loose debris. Use the plastic scraper on the floor of the oven and vacuum or wipe out the crumbs.
- Apply bicarb paste. Mix about half a cup of bicarb soda with a few tablespoons of water to form a spreadable paste. Spread it over the walls, floor and inside of the door, thickest on the brown spots. Avoid the heating elements and the fan.
- Wait. Leave it for at least several hours, ideally overnight. The paste will turn brown as it lifts grease.
- Scrape and wipe. Work the paste off with the plastic scraper and a damp cloth, rinsing the cloth often.
- Spray with vinegar. A light mist of white vinegar on any remaining bicarb residue makes it foam and lift. Wipe it away. Use vinegar on its own, never alongside bleach or a commercial oven cleaner.
- Rinse. Wipe everything with clean warm water until no white film remains, then dry with a microfibre cloth.
- Repeat on stubborn spots. A second, shorter round of paste on a few patches is quicker than scrubbing hard and scratching the enamel.
Using a commercial oven cleaner instead
Commercial oven cleaners work faster on heavy build-up but are strong products. Read the whole label first. Check it is suitable for your oven type, wear gloves and eye protection, keep the room ventilated, keep children and pets away, and do not spray onto elements, fans, seals or hot surfaces. Do not mix it with other cleaners, and rinse thoroughly afterwards.
Racks and trays
Lay an old towel in the bath or laundry trough to protect the surface, put the racks on top and cover them with hot water and a good squeeze of dishwashing liquid, or a few spoonfuls of bicarb soda. Leave them to soak for a few hours, then scrub with a non-scratch scourer and the toothbrush for the corners where the wires join. Rinse and dry before putting them back.
The door and glass
Grease often collects between the panes of the door, and inspectors notice it. Many oven doors can be removed and the inner glass taken out; check your manual for the correct method and only do it if the manual describes it. Otherwise:
- Clean the inner glass with bicarb paste, then wipe and polish dry.
- Clean the outer glass with a little dishwashing liquid in warm water or a glass cleaner, then buff to remove streaks.
- Wipe the door seal gently with warm soapy water. Do not soak or scrub it, and keep bicarb and oven cleaner off it.
- Clean the hinges, the top edge of the door and the handle.
Pyrolytic and catalytic ovens
Pyrolytic (self-cleaning)
Remove racks and accessories as the manual directs, then run the pyrolytic cycle. It heats the oven to a very high temperature and turns residue to ash. When it has fully cooled, wipe the ash out with a damp cloth. Do not use commercial oven cleaners or abrasive scourers inside unless the manufacturer says they are safe.
Catalytic liners
Catalytic liners are rough panels that absorb grease during cooking. Do not scrub them or use oven cleaner on them, as that can damage the coating. Follow the manual, which usually recommends running the oven empty at high heat for a set time.
Finish the cooking area
- Knobs and control panel: wipe with a damp cloth and a drop of dishwashing liquid. Avoid spraying liquid directly onto electronic controls.
- Storage drawer under the oven, if there is one: empty and wipe.
- Cooktop and rangehood: degrease the surfaces and wash the metal rangehood filters in hot soapy water.
- Splashback and the side panels of the oven cavity.
The oven is one item on a long list. Our end of lease cleaning checklist covers the rest of the kitchen and house, and how long an end of lease clean takes explains why heavy oven build-up adds time.
When the oven beats you
Years of carbonised grease can take more than one session. If you run out of time, ask Prime Cleaners Melbourne for a free written quote for end of lease cleaning, and mention the state of the oven when you do.
Quick answers
Can I use steel wool on the inside of the oven?
It is best avoided. Steel wool and harsh abrasives can scratch the enamel and the glass, leaving marks that look worse than the original grease. Use a plastic scraper and a non-scratch scourer, and let bicarb paste or a suitable oven cleaner do the work.